Build a spool holder for 3
reels of rope light or more.

Parts List:

1. (4) 10' lengths of 3/4" schedule 40 pvc pipe (Lowe's, Home Depot)
   
2. (3) 3/4" tees
   
3. (16) 3/4" 4 way LT (ChristmasLightShow.com Click Here to order)
   
4. (15) Spears 3/4" Snap-on Tees (ChristmasLightShow.com Click Here to order)
   
   

   
   
   

	Build Bottom Structure
Click image to enlarge	To start, gather four of your pre cuts of 16" and 10" lengths, plus 4 of the 4 of the 3/4" 4 way LTs.
Click image to enlarge Click image to enlarge Click image to enlarge	Glue oneof the 4 way LTs on each end and make sure they are flush on a flat surface as seen in the picture.             Continue until you have a complete square.
Click image to enlarge	Take the four 10" pieces of pre cut 3/4" pipe and glue them into the 4 way LT as seen in picture.
Click image to enlarge Click image to enlarge	Now make another square structure.     Place it on top and glue it together.
	Build A Reel Holder
Click image to enlarge	Glue two Spears 3/4" Snap-on Tees together. Make sure they are glue perpendicular to each other.
	Build A Rope Light Feeder
Click image to enlarge	Glue one Spears 3/4" Snap-on Tees and one 3/4" 3 way tee together. Make sure they are glue perpendicular to each other.
Click image to enlarge	Snap the double Spears piece to the structure you just built, as seen in picture.
Click image to enlarge	Take you 21" pre cut piece of 3/4" pvc pipe and run it through a spool of
Click image to enlarge Click image to enlarge	Follow the steps from the beginning to make this piece.     Then add your reel holder and rope light feeder.
Click image to enlarge	Add your second reel and build a third level and stack it on.
Click image to enlarge Click image to enlarge	This is your final look.